Impco air valve system
Global Autogas Supplies, offer a range of after-market LPG systems to suit most makes and models of vehicles.

Installation
Installation of the system is carried out at authorised workshops, which specialise in LPG installations. All accredited installers carry out quality workmanship and are familiar with our product range.

Warranty
Systems carry the standard manufacturers warranty. *Low cost warranty available; New vehicles 3yr 100,000km, Used vehicles 2 yr 30,000km.
The Mazda E Series Van utilises specific vehicle components that minimise alterations to the vehicle.
*Conditions Apply

Fuel Selector Switch (dash mounted)
The fuel selector switch is located on the dash of the vehicle, as shown in the diagram. The switch has 3 positions detailed below;

LPG - in this position the vehicle will operate on LPG fuel.

Centre - in this position the engine will not operate on either fuel, additionally the engine will not crank.

ULP - in this position the engine will operate solely on unleaded petrol.

Fuel Gauge (Interface)
The level of LPG is measured using the existing petrol gauge on the dash of the vehicle. This is referred to as an interface gauge, whereby the one gauge measures 2 different fuels, depending on the fuel operation of the vehicle at the time.

During LPG operation, the fuel gauge will show the level of LPG in the LPG storage cylinder; the same gauge will show the remaining petrol in the petrol tank when operating on ULP (petrol).

	LPG filler location The LPG filler for the Mazda E2000 (SWB, MWB & LWB) is located on the right hand side of the vehicle, below the existing petrol filler.
	Cylinder location The LPG storage cylinder for the Mazda E2000 (SWB, MWB & LWB) is located under the rear of the vehicle. Medium and long wheel base cylinders hold a useable 65 litres of LPG, and the short wheel base cylinder holds a useable 49 litres of LPG. The spare wheel is relocated to inside the vehicle cargo area ulilising an engineered vehicle specific bracket.

All LPG cylinders are tested in accordance to the relevant design rules and Australian Standards.